Ab-soft 6424 User Manual Page 1

OUTDOOR STORAGE BUILDINGOWNER’S MANUALMODEL 642430” OUTDOOR STORAGE EXTENSION KITOUTDOOR STORAGECopy

10c. Slide a Threaded Rod through the Truss Support Brace and the top of the Truss Connector.TD (2) d. Secure the top and bottom of the Threaded Rod

1112a. Add Truss.13a. Add Roof Panels (114) and Roof Supports (AD).b. Add a center Roof Cap (117).Roof Panel RidgeRoof PanelWall

1214a. Add next Truss.15a. Add Roof Panels (114) and Roof Supports (AD).b. Add a center Roof Cap (117).

13b. Add the last Center Roof Cap (117) and the End Roof Cap.16a. Add Roof Panels (114) and Roof Supports (AD).17a. Add Skylights

14Congratulations on your Lifetime® Outdoor Shed purchase. By following the instructions below, your new Lifetime shed should provide you with years o

BEFORE BEGINNING ASSEMBLY Identify and inventory all parts using the checklist boxes on the Parts List. Keep the hardware bags and their contents sep

3110114125AETKTBTAACABAAADHARDWARE IS ACTUAL SIZE(Unless otherwise indicated)TITJTDTFTHTEIf you are Installing a New Shed1. Check contents of boxes an

41a. Remove last three skylights.2a. Remove the back 3 roof caps.3a. Remove the back Roof panels and Roof support bars.**Save all hardware for re-a

54a. Remove the next Roof panels and Roof support bars.5a. Remove the Roof Truss.

66a. Remove the last two Side Wall Panels.7a. Slide the back section of the shed away from the front. You will need to tip the back section forward

7a. Remove plastic sheeting from Window (AE) and slide Window into slot on the Window Wall Panel (125). Attach a Window Latch (TK) above each corner

89a. Add new Floor Panel (110). Then, slide the back section into place and connect the floor panels (you will need to tip the panels forward slightly

9b. Use Truss Connector (TA) to attach Roof Truss Channels at top. Secure with Screws (TF) and Nuts (TE). Before completely tightening, lay assembly